How to use

NOTE: Detailed instructions included in the kit.
1. Apply a dot of Gel Adhesive to the circled target area of the pre-buffed underside of the artificial nail tip that will meet the natural nail.

2. Gently press the nail tip on the natural nail starting from the cuticle area to the free edge with constant, firm pressure, making sure to remove any air bubbles. (Tip: If any bubbles are present or the gel is not filling to the free edge, remove the nail tip and apply more Gel Adhesive and reposition.)

3. While gently pressing the nail tip with your other hand, place your fingernail on the LED Lamp motion sensor to flash cure for 5-7 seconds. This will secure the position of the nail tip. Make sure the cuticle edge of the nail tip is securely adhered and cured to prevent nail lifting or hair catching. (Tip: Gel is not completely cured yet at this stage. Remove excessive gel around the skin and underneath the tip with a manicure stick before moving onto the full minute cure.)

4. Finish cure for an additional 1-2 minutes to make sure sides and edges are fully cured. (Tip: Clear and light color nail tips can be cured in 1 minute. 2 minute cure is recommended for darker color nails and designed nails. For French and ombré design nails, turn your finger upside down and cure for 1 additional minute to make sure the gel is cured thoroughly.)

5. Repeat steps 1-4 on all ten nails. Keep the Gel Adhesive container tightly closed after use. (Tip: If there is any excessive gel underneath the nail tip, wipe its tacky layer with a cotton swab soaked with alcohol.) Tip: Trim and file the artificial tip to desired length and shape with the rough side of the nail file.

Hazards and Cautions

CAUTION: Gel Adhesive: Keep out of reach of children. For professional use only. Can cause an allergic reaction. Avoid skin contact. Read directions for use carefully. Prep Pad: Keep out of reach of children. LED Lamp: Read directions for use carefully. Do not use in bathrooms. Do not look directly at the lamp light.

Important info

Country of Origin: China

Address: UK: KISS Products Europe Limited, Obelis UK Limited, Sandford Business Park, OX4 6LB
Oxford, United Kingdom

EU: KISS Products Europe Limited, Unit 1, M50 Business Park, Ballymount Avenue, Ballymount, Dublin 12 K6C5 Ireland

Ingredients

ABS (Acrylonitrile Butadiene Styrene)